Online manual not for resale purposes – BLITZ Toyota Celica Compressor System User Manual

Page 31

Advertising

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be
reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan)

Genuin

Com

puter

Red wire

(thick)

Ground wire.

With 6mm

Red wire (thin)
Ignition ON

Back wire (thin)
Ground wire to the engine
computer.

Yellow wire.
To the engine computer
A wire.

(C. 58) Clutch

Blue wire (thin)

To the relay.

Blue wire (thin)

To the switch.

To the positive

battery

terminal

With 8mm

round

(C. 59) Relay

Fuse

Coupler

Wiring Diagram

Compressor’s

Magnetic clutch

(31) Installation of the (C.63) Access computer.

①

Remove the lid from the computer box in the

engine room.

②

Disconnect the computer’s connectors.

③

Remove the genuine computer from the

computer box by removing the bolt holding the

computer stay.

④

Install the (C.61) female wire connector to the

white wire from the access computer.

⑤

Remove the stay from the genuine computer

and install it to the access computer.

⑥

Install the access computer with the steps

opposite from removing the genuine computer.

(32) Installation of the (C. 58) Clutch switch.

①

Install the (C.59) relay harness’s relay box at the

location shown in the figure. (See next page)

②

Install the (C.58) clutch switch box using a

two-sided tape. (See next page)

③

Connect the harness coupler from the

compressor to the (C. 59) relay harness coupler.

④

Connect the re wire from the (C.59) relay harness

coupler (6mm round terminal) to the ground

shown in the figure. (See next page)

⑤

Connect the red wire from the (C.59) relay box

(8mm round terminal) to the positive terminal of

the battery.

⑥

Connect the blue wire from the (C.59) relay box to

the blue wire at the (C.58) clutch switch.

⑦

Connect the (C.58) clutch switch yellow wire to

the white wire from the (C.63) access computer.

⑧

Connect the black wire from the (C.58) clutch

switch to the ground line of the computer (brown

wire) using an electro tap.

⑨

Connect the red wire from the (C.58) clutch

switch to the ignition line of the computer (black

and orange wire) using an electro tap.

※

Be careful not to damage the wires while using

the electro tap.

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals