CiDRA SONARtrac GVF-100 - Manual (Page 16)

Copyright © 2006 CiDRA Corporation Page 5-4
20675-01 Rev 02
•
Ensure all power cords, sensor to transmitter cable and signal
cables are properly routed to eliminate damage to them. Cable
conduit may be desirable to minimize potential damage.
•
Prior to servicing, lockout all electrical power sources.
•
Care should be taken when using the operator keypad to avoid
touching any electrical connection or contact points.
•
Do not wear rings or wristwatches when servicing this equipment.
•
Use only the specified fuse(s) with the correct type number,
voltage and current ratings as referenced in the appropriate
locations in the service instructions or on the equipment.
5.3.6 General Cautions
Observe these cautions when operating or servicing this equipment:
•
Read the instructions for proper input voltage range selection.
•
There are no user serviceable parts inside the SONARtrac
TM
sensor band. Modification or disassembly may void the system
warranty.
•
Disconnect power to transmitter prior to replacing fuse(s).
•
Use only CiDRA specified replacement parts.
•
Follow static sensitive device precautions when servicing.
•
This product should only be powered as described in the manual.
•
Do not run power and signal wires in a common conduit.