COATS 700 Solid State Wheel Balancer User Manual
Page 4
1. Read all instructions
2. Do not operate equipment with a damaged cord or if the equipment has been dropped or
damaged – until it has been examined by a qualified serviceman.
3. Do not let cord hang over edge of table, bench, or counter, or come in contact with hot manifolds
or moving fan blades.
4. If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment should be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
5. Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the
plug from the outlet. Grasp plug and pull to disconnect.
6. To reduce the risk of fire, do not operate equipment in the vicinity of open containers or
flammable liquids (gasoline).
7.
Adequate ventilation should be provided when working on internal combustion engines.
8. Keep hair, loose clothing, fingers, and all body parts away from moving parts.
9. To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
10. Use only as described in this manual. Use only manufacturer’s recommended attachments.
11. ALWAYS WEAR SAFETY GLASSES. Everyday glasses only have impact resistant lenses, they are
NOT safety glasses.
12. Do not disable the hood safety interlock system, or in any way shortcut safety controls and
operations.
13. Be sure wheels are mounted properly, the hub nut engages the arbor not less than 4 turns, and
the hub nut is firmly tightened before spinning the wheel.
14. Maintain all electrical cords in good repair. Do not operate damaged equipment until it has been
examined by a qualified service technician.
15. Be sure the balancer is properly connected to the power supply and electrically grounded.
16. Read and understand this manual before operating. Abuse and misuse will shorten functional life.
17. Keep guards and safety features in place and in working order.
18. Wear proper clothing. Safety toe, non-slip footwear and protective hair covering to contain hair
are recommended. Do not wear jewelry, loose clothing, neckties, or gloves when operating the
balancer.
19. Keep work area clean and well lighted. Cluttered and/or dark areas invite accidents.
20. Disconnect balancer before servicing.
21. Repair or replace any part that is damaged or worn and that may cause unsafe balancer
operation. Do not operate damaged equipment until it has been examined by a qualified service
technician.
22. Never overload or stand on the balancer.
23. Do not allow untrained persons to operate machinery.
iv • COATS 700 Balancer
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS