COATS 700 Solid State Wheel Balancer - Manual (Page 9)

C. Optional Combi Adapter—Can be used for 3, 4,
5, 6, 8, or 10 lug wheels by installing the appropriate
number of swivel plates.
Figure 5 - Combi Adapter (optional)
1. Install a swivel plate over the adapter plate hole
marked 3 4 5 and secure with a shoulder bolt.
Align the mark on the plate with the dot on the
number gear. Do not tighten the bolt.
2. Install swivel plates next to the appropriate
numbers (next to the 3’s for 3 and 6 lug wheels,
the 4’s for 4 and 8 lug wheels, and the 5’s for 5
and 10 lug wheels). Align the marks on the
plates with the dots on the number gear. Secure
with a shoulder bolt, but do not tighten.
3. Attach the adapter to the wheel. Rotate the
swivel plates until the lugs align with the holes in
the wheel.
4. Install the lug nuts and tighten with the adapter
wrench. Use a crossing (star) pattern to tighten
the lug nuts. Reverse the lug nuts as necessary
for proper fit in the lug hole on the wheel.
5. Tighten the swivel plate shoulder bolts with the
allen wrench.
6. Align the bolts on the back of the adapter with
the holes in the faceplate. Thread a faceplate nut
onto each bolt. Hand tighten the nuts while
rotating the wheel to ensure proper centering.
The lug nuts must be
centered and threaded at
least four full turns.
Reverse the lug nuts as required for best fit. Use
only the adapter wrench furnished. Do not use air
tools or impact wrenches.
D. Optional Light Truck Cone—Allows secure
mounting of most light truck wheels.
1. Lift wheel onto threaded shaft. Push it back
against the faceplate.
2. Slide cone onto shaft, and center in wheel
center hole. The cone lip will help hold the wheel
while tightening the hub nut.
Figure 6 - Light Truck Cone (optional)
3. Thread the hub nut onto the shaft and tighten
against the cone completely. The wheel must be
forced firmly against the faceplate. The hub nut
must engage the threads for at least three full
turns.
Failure to tighten the hub
nut properly may result in
the wheel dismounting,
causing personal injury and property damage.
Selecting Operating Options
Gram/Ounce
Toggles unit between weight
readings in ounces or grams. Press
and hold SHIFT and press
GRAM/OUNCE
Round Off Toggles unit between normal mode
(0.25-ounce increments) and fine
balance mode (0.01-ounce/1-gram
increments). Normal mode is 5-gram
increments from 0 to 50, and 10-gram
increments from 50 to 100. Press and
hold SHIFT and press ROUNDOFF.
Calibrate Places unit in the calibration mode.
Press and hold SHIFT and press
CALIBRATE.
Mode Selects the balancing mode. Press
MODE until the LED above the
desired mode is illuminated.
COATS 700 Balancer • 3
WARNING
WARNING
Faceplate
Light Truck
Cone
Hub Nut
Swivel Plate
Swivel Plate
Bolt
Washer
(optional)
Faceplate
Nut
Number
Gear
Center
Bushing
Alignment
Mark
Combi Plate
Alignment