Condux Gulfstream 200 Micro Fiber Blower - Manual (Page 14)

14
7.
figure 13. Tractor Drive forward figure 14. Adjust Speed Control
Blower Operations
A. ENgAgE AIR
Start compressor. Slowly open the air control valve to allow air flow to the air block by
turning the control valve knob clockwise.
ImPoRTANT: Do not exceed 175 PSI when operating the unit.
!wARNINg: forced air creates flying debris. Always wear personal
protective equipment.
b. VERIfY ADjuSTAbLE PuSh foRCE
Verify adjustable push force is set to the established crash test value and the speed is
at minimum.
C. ENgAgE TRACToR DRIVE
The tractor drive can be operated in forward and reverse. For installation, engage the
tractor drive in forward by depressing the tractor drive control switch to the “F” position
as shown. (See figure 13).
D. ADjuST SPEED
Use the Speed control knob to adjust the tractor drive speed to ensure smooth
installation and match the amount of air pressure being used so that the forces are
working together, not against one another. (See figure 14). Counterclockwise
increases speed and clockwise decreases speed.
E. INSTALL fIbER