Set up the blower – Condux Gulfstream 200 Micro Fiber Blower User Manual
Page 8
8
Set Up the Blower
This manual contains setup and operating instructions for the Gulfstream 200 micro
fiber blower.
A. DETERmINE fIbER SIZE
Determine size of fiber to be installed. To provide optimal traction and grip, if fiber
diameter is 1.5mm or less, the top belt of blower must be changed to a flat belt which
is included in the common parts kit. This flat belt is to be used in combination with the
bottom grooved belt, so that adequate contact and proper push force can be applied
to the fiber. Refer to Section 9 for belt replacement instructions.
b. SELECT CAbLE SEAL & DuCT PACk
Choose the correct cable seal and duct pack for the particular application according to
duct and cable size. Refer to Cable Seal and Duct Pack selection charts.
5.
CAbLE SEAL SELECTIoN
CAbLE oD (mm)
CAbLE SEAL kIT PN
DuCT PACk PN
0.8-1.5
08783074
08783051; 08783052; 08783053
1.5-2.0
08783057
08783051; 08783052; 08783053
2.0-2.5
08783058
08783051; 08783052; 08783053
2.5-3.0
08783064
08783051; 08783052; 08783053
3.0-3.5
08783059
08783051; 08783052; 08783053
3.5-4.0
08783060
08783052; 08783053
4.0-4.5
08783061
08783052; 08783053
4.5-5.0
08783062
08783052; 08783053
5.0-5.5
08783063
08783052; 08783053
DuCT PACk SELECTIoN
DuCT oD (mm)
DuCT PACk PN
5.0mm
08783051
7.0mm
08783051
8.0mm
08783052
8.5mm
08783052
10.0mm
08783052
12.0mm
08783053
12.7mm
08783053