Prepare conduit for cable – Condux Hand Held Micro Fiber Optic Blower User Manual
Page 9
Advertising
9
Prepare Conduit for Cable
1. Remove
Conduit Pulling Eye from receiving end of Conduit.
2. Open Handheld Blower (See Figure 12)
3. Pour
recommended
(silicon-based) lubricant into Conduit opening before
Foam Carrier ¼ of the total recommend amount (See Figure 13) foam
carriers are not provided with the Handheld blower. (See Page 19 for
recommend amount of lubrication).
4. Insert foam into conduit (See Figure 14).
5. Insert
Seal Disk in venturi slot if not already in place. (Figure 15).
Figure 12 Open handheld blower
Figure 13 Add
lubricant
Figure 14 Insert foam carrier
Figure 15 Insert seal disk
Advertising