Bryant HUM-56-1 - Manual (Page 5)

INSTALLATION OF HUMBBSFP1016-A--
FAN POWERED HUMIDIFIER
Bryant’s HUMBBSFP1016-A-- fan powered humidifier can only
be installed on the supply plenum of a forced-air system. This unit
requires an external 115-vac (fused) plug-in receptacle near the
equipment for proper operation.
It is recommended to install the humidifier where it can be easily
serviced. Pad access door can be easily converted from right to the
left hand side. Always install humidifier downstream of an
electronic air cleaner.
I. INSPECT PACKAGE AND CHECK EQUIPMENT
Inspect contents of packaged humidifier. File claim with shipping
company prior to installation, if shipment is damaged or incom-
plete.
The package should contain:
1. Humidifier and media assembly
2. Humidistat
3. Template
4. Owner’s Manual
5. Warranty Certificate
6. Solenoid valve
7. Saddle valve assembly with adapter
8. Four sheet metal screws
9. Foam tape
10. Noise suppressor (use for water pressure over 60 psi)
11. Worm clamp for field-supplied drain tube
12. Humidifier maintenance instruction sticker
13. Bryant logo label
II. SELECT LOCATION (SEE FIG. 7.)
Humidifier must be installed on supply plenum only. If furnace has
air conditioning coil, be sure humidifier does not interfere with coil
ends. Remember to provide clearance for maintenance and evapo-
rator pad removal.
To reverse pad access from right to the left side:
1. Remove side door and media pad assembly.
2. Remove 4 screws and separate top assembly from lower
mounting base. (See Fig. 8.)
3. Rotate lower mounting base 180 degrees, so side access
door is now on left.
4. Snap together top assembly to mounting base and reinstall
screws.
5. Replace media pad assembly (with distributor reservoir up)
and side access door.
CAUTION: When re-installing media pad assembly into
plastic housing, insure the assembly drain stub aligns into
the drain outlet located in bottom of humidifier. Unit can
leak if drain stub does not align with drain outlet. (See
Fig. 9.)
IMPORTANT: Make sure front housing assembly with electrical
cord is facing down.
III. PREPARE PLENUM OPENING (SEE FIG. 2.)
1. Use template for marking humidifier opening.
2. Tape in place on plenum making sure template is level.
IMPORTANT: For humidifier to operate properly it must be
level and mounted on a vertical surface.
3. Drill four 1/8-in. holes in plenum.
4. Cut opening in plenum using heavy solid lines on template
as a guide.
Fig. 7—Installation of HUMBBSFP1016-A--
Fan-Type Humidifier
A97098
VERTICAL HORIZONTAL
HORIZONTAL
"N" COIL
Fig. 8—Reversing Door Access
on HUMBBSFP1016-A--
A96049
Fig. 9—Media Pad Assembly Installation
A97108
MEDIA PAD
ASSEMBLY
HOUSING
ENCLOSURE
DRAIN OUTLET
DRAIN
OUTLET
VINYL DRAIN
TUBING
—5—
→