Belkin PUREFILTER PF60 - Manual (Page 16)

15
Pur
eA
V P
o
w
er C
ons
ole
Hookup and Installation
Step 8
Connect High-Current Audio Filter (Bank 06)
This outlet is specifically designed to filter out AC line noise while
delivering maximum current to power-hungry amplifiers and other
high-current audio components. These outlets should be programmed for
"Delay". This allows your high-current amplifiers to turn on last and turn
off first, avoiding that annoying, and potentially damaging "thump" from
getting to your speakers.
A. Attach PureAV power cord labels to each component’s power cord
before you plug the cord into the corresponding outlet on the Power
Console.
B. AMP 1 – Connect your main amplifier power cord to the outlet labeled
“AMP 1”.
C. AMP 2 – Connect your secondary amplifier power cord to the outlet
labeled “AMP 2”.
Note: You can connect any type of high-current audio component into
any of the high-current outlets. You are not limited to the
components listed above.