Belkin PUREFILTER PF60 - Manual (Page 22)

Pur
eA
V P
o
w
er C
ons
ole
Troubleshooting
21
Power Console is not providing power
• Check to ensure that the Power Console is plugged into a properly
grounded AC wall outlet. Some outlets require a wall switch to be turned
on in order to deliver power to the outlet.
• Too many devices may be plugged into the Power Console, which are
overloading the unit and tripping the overload circuit breaker. The Power
Console is not designed to handle current loads larger than 15 Amps or
1800 watts. Try unplugging some devices and resetting the circuit
breaker located on the end of the Power Console
To reset the circuit breaker: Wait at least 10 minutes after the circuit
breaker was tripped before attempting to reset the breaker. Press in
the button located next to the power cord on the end of the unit to
reset. Power should be restored to the outlets on the Power Console.
• Your components may be plugged into a “Switched” outlet and the
outlet is not switched on. Check to ensure that the “Switched ON”
indicator on the Control Panel is illuminated. If the light is not illuminated,
press the “Switched” button on the front of the Power Console unit until
the “Switched ON” indicator is illuminated. You should now have power
to all of the switched outlets.
• Your components may not be turned on. Power may be flowing from the
Power Console, but if the power switch on your component is not turned
on then your component cannot receive power. Turn on the power switch
on your component.
• The surge protection components may be expired. The Power Console is
designed to stop delivering power to all outlets when the surge-protection
circuitry is not functioning properly or is expired. Call Belkin Customer
Service for assistance.
• The Power Console may be defective. Call Belkin Customer Service
for assistance.