Belkin PUREFILTER PF60 - Manual (Page 18)

17
Pur
eA
V P
o
w
er C
ons
ole
Hookup and Installation
Step 10
Connect your Coaxial-Cables/DSS Lines
Your PureAV Power Console comes with three pairs of coaxial-cable
connections to protect your system from dangerous electrical disturbances
that can travel down your coaxial-cables lines. You will need additional
coaxial cables to connect the Power Console to your home theater
components.
A. Cable TV – Connect the incoming cable television coaxial-cable line to
the connector labeled “Cable IN”. Connect one end of a second coaxial
cable to the connector labeled “Cable OUT”. Connect the other end of
this cable to your cable TV tuner.
B. Satellite (DSS) TV – Connect the incoming satellite television coaxial-
cable line to the connector labeled “SAT IN”. Connect one end of a
second coaxial cable to the connector labeled “SAT OUT”. Connect the
other end of this cable to your satellite TV tuner.
C. Antenna – Connect the incoming TV or radio antenna cable line to the
connector labeled “Antenna IN”. Connect one end of a second coaxial
cable to the connector labeled “Antenna OUT”. Connect the other end
of this cable to your TV or radio equipment.
D. HDTV, Broadband, or other Coaxial-Cable Lines – Connect any other
incoming cable lines you want to protect to the connector labeled “AUX
IN”. Connect one end of a second coaxial cable to the connector labeled
“AUX OUT”.
Note: We have included labels for the Coax IN and Coax OUT lines if
needed for better organization.
IMPORTANT WARNING – To sufficiently safeguard all of your equipment
from damage resulting from a power surge, all of your incoming coaxial-
cable lines should be properly grounded. Contact a licensed electrician
to verify that all of your cable lines are properly grounded to a cold
water pipe or ground rod.