Eberspacher Calltronic 01 - Manual (Page 2)

2
D
S
GB
F
Contents Page
Operating instructions
Operating the CALLTRONIC .................................. 2
General operating information ............................... 2
Reset PIN .............................................................. 2
Operating modes ................................................... 3
Operating the heater via the numeric keys
on the telephone ................................................... 3
Functions
a) Select heating / ventilation mode .................. 4
b) Heating / ventilation running time .................. 4
c) Special functions ............................................ 5
Fault correction ..................................................... 5
Contents / Operating Instructions
Operating the CALLTRONIC
The CALLTRONIC is an operating element, to
remotely operate the heater with a DTMF telephone
or mobile phone via the GSM network from a dis-
tance. You can select between the heating and
ventilation operating modes. The following setting
times are available for the heating period: 10, 20,
30, 40, 50, 60, 90 and 120 minutes.
If preselected mode is required, a mini clock must
be used instead of the push-button.
Hazard!
• Pacemakers and hearing aids can be negatively
influenced.
• The SIM card and the SIM cardholder can be
removed at any time – small children could
swallow them.
Please note!
• When calling the CALLTRONIC , additional costs
are incurred due to the telephone charges.
• The range depends on the network operator
(“radio hole” – transmission gaps).
• It is important that the vehicle manufacturer’s
instructions and regulations for the installation
and operation of a mobile phone or GSM module
are observed and complied with.
• The CALLTRONIC can only be operated with an
external GSM outdoor antenna in vehicles with
a metalised windscreen.
General operating information
• The voice output has to be waited for before enter-
ing the numeric key, otherwise the function of the
key will be ignored.
• The connection is terminated after 30 seconds
without input.
• Reset PIN:
If you have forgotten your PIN number for setting
up the connection to the
CALLTRONIC , you can
reset it as follows:
1 1. Sit in the vehicle.
1 2. Switch off the heater if it is switched on.
1 3. Phone the CALLTRONIC using the telephone.
1 4. Use the push-button or the mini clock to switch
the heater on following the voice output “Enter
PIN“ within 30 seconds. At the end of the 30
seconds, the heater must be switched on,
otherwise the programme is aborted and the
process has to be repeated.
1 5. Wait until the voice output “PIN invalid“.
1 6. Voice output “Enter PIN“.
1 7. Enter the PIN number “0000“.
1 8. Voice output “Enter PIN“.
1 9. Enter the PIN number “0000“ again.
10. Voice output “PIN OK“.
11. Voice output “Input function“.
The PIN number “0000“ is now stored for starting
the device.
You can change the PIN number at any time, as
described in the table on Page 5.
Page
Installation instructions
Installing the CALLTRONIC ................................. 6
Attaching the windscreen antenna ....................... 6
Insert SIM card ...................................................... 7
Installing the operating elements .......................... 7
Insert fuse and check function ............................. 7
Technical data ....................................................... 7
Circuit diagrams parts list ..................................... 8
Circuit diagrams at the end of these instructions