Eberspacher Calltronic 01 - Manual (Page 5)

5
D
S
GB
F
c) Special functions
Numeric key Function Voice output
5 The following language is selected by pressing Key 5.
Repeat the function until the required language is announced.
Language selected: Input command
• German (in the selected language)
• Swedish
• English
• French
The following function, numeric key 6, only applies for the trade appliances (retrofit) –
diagnosis cable (blue / white) must be connected
6 Enquire heater condition • Heater OK – Input command
(Diagnosis analysis) • Heater not OK – Input command
• Input invalid – Input command
(if diagnosis cable not connected)
7 Change PIN Input new PIN
xxxx Enter new PIN Input new PIN
xxxx Enter new PIN • PIN OK – Input command
(for confirmation) • Input invalid – Input command
8 No function Input invalid – Input command
9 No function Input invalid – Input command
Problem Possible cause Possible corrective measure
No connection No supply voltage Check fuse and wiring
to the CALLTRONIC Weak signal Change location of the vehicle; check antenna
Outside of the GSM supply area Check the supply range of the network operator
Network block set Check network blocks
Network overloaded Call again later
SIM card invalid Call using another phone network operator
SIM card incorrectly inserted Ensure that the SIM card has been correctly
inserted; the card holder must lock home
SIM card contacts soiled Clean the SIM card with a dry cloth
SIM card with wrong number Only SIM cards with 3 volts possible
of volts
SIM card damaged Carry out a visual check;
give SIM card back to network operator
Fault correction
If problems occur while you are using the
CALLTRONIC , first try to find a solution in the
following list.
If the problem continues, please contact an
Eberspächer service workshop.