ECOXGEAR C2CDRW: Retrowriter - Manual (Page 17)

Er All
Select this to erase all the tracks.
To cancel the erasing or unfinalizing process, press the STOP button ( ).
4
The remaining time for the operation appears in the display. When the operation has
been finished, the display returns to the track/time display.
During erasing/unfinalizing, no buttons will work.
Never turn the power off nor unplug the power cord.
 This operation cannot be undone. If you are going to erase a track or tracks, make sure
that they are recordings that you really want to erase.
(1). Press and hold the “Erase” button until the display shows “Erase All”.
(2). Press play ( ) button to begin the erase process.
(3). Display will show 0000000 to confirm the disc is clear.
A copied CD-RW disc from another unit can't be erased one by one in this unit, you can
only erase entire disc.
33
Erase or Unfinalize a CD-RW
It is possible to erase the last recorded track, it is also possible to erase a whole disc.
Erase procedures are possible only on an unfinalized CD-RW disc. If a CD-RW disc has
been finalized, unfinalize it prior to erasure. Remember that it is not possible to perform any
Erase or unfinalize procedures on a CD-R disc.
1. Press the CD button to select “CD”.
2. Load a recorded CD-RW.
3. Press the ERASE button in the stop mode.
“Er” and the last track number appear when the disc hasn't been finalized. Each time the
ERASE button is pressed, the display changes as follows:
“Er” and the number of the last track recorded on the disc
Select this to erase the last track on the disc.
 This will not appear when only one track is recorded on the disc.
(1). Wait until “Busy” disappears on the display.
(2). Press the ( ) button to begin erasing the last track.
(3). Repeat to press Erase button to continue the next track.
32
CD
ERASE