ECOXGEAR C2CDRW: Retrowriter - Manual (Page 4)

Discs
 Depending on the quality of the disc and the condition of the recording, some CD-R/CD-
RW discs may not be playable.
 Always place the disc on the disc tray with the label side upward(compact discs can be
played or recorded only on one side)
 To move a disc from its storage case, press down on the center of the case and lift the
disc out, holding it carefully by the edges.
 If the disc becomes dirty, wipe the surface from the center
Hole outward towards the outer edge with a soft, dry cloth.
 Never use such chemicals as record spray, antistatic sprays or fluid, benzine or thinner
to clean the discs. Such chemicals will do irreparable damage to the disc's plastic
surface.
 Discs should be returned to their cases after use to avoid dust and scratches that could
cause the laser pick up “skip”.
 Do not expose discs to direct sunlight or high humidity and temperature for extended
periods. Long exposure to high temperatures will warp the disc.
 Printable CD-R and CD-RW discs are not recommended, as the label side might be sticky
and damage the unit.
 Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a
ball-point or hard-tipped pen, as this may cause damage to the recorded side.
 Do not use CDs with an irregular shape(octagonal, heart shaped, business card size,
etc).CDs of this sort can damage the unit:
 If you have any doubts about CD-R/CD-RW discs, read the precautions supplied with the
disc, or contact the disc manufacturer directly.
6 7
Connections
Caution:
 Switch off the power to all equipment before making connections.
 Read the instructions of each component you intend to use with this unit.
 Be sure to insert each plug securely. To prevent hum and noise, avoid bundling the signal
interconnection cables together with the AC power cord.
Antenna
Tune in a station and extend the antenna to find the best position for the reception.
AUX IN
An external (auxiliary) audio source (ie., personal CD player or MP3 player) can be
connected to this unit and heard through the speakers.
(1) Plug one end of cable (included) into the LINE IN socket on the back of the unit.
(2) Plug the other end of the cable into the headphone or Line Out socket of the external
source.
LINE OUT
1) Plug the RCA Cables into the Line Out jacks located at the rear of the unit making
sure that the red RCA Cable is inserted into the red jack and the white RCA Cable is
inserted into the white jack.
2) Plug the other ends of the RCA Cable into the auxiliary input (AUX) on your TV, home
entertainment receiver or other music system, again being sure that the correct color
coded jacks are used.
3) Turn the unit on using the On/Off/Volume Knob. Do not turn up the volume on your Unit.
Instead adjust the volume on your TV or home entertainment receiver.
AC Power Cord
Plug this power cord into an AC wall socket.
A
R L
AUX IN
R L
LINE OUT
A
B C
D
B
C
D