Elkhart Brass Vulcan 8593-xx EXT - Manual (Page 21)

Page 21
Caution:
While reassembling the handheld remote, ensure both battery and antenna
leads do not become pinched.
Figure 19
Transmitter Security Settings
3. 81327101, 81327201, 81353101 and 81353201 Secondary, Primary, Panel
Mount, and OEM Transmitters
a) Disconnect the power connector to the transmitter.
b) Open the back cover of the transmitter after loosening the screws.
c) Remove the red and black power leads from the power conversion board and place
the cover to the side.
d) Locate the security code switches on the transmitter circuit board (see Figure 19).
e) Change the switches to match the settings of the RF Receiver/Control Module except
switch A1. One incorrect setting will prevent the system from working.
f) Reconnect the power leads. The Red lead is attached to the Positive (+) terminal; the
black lead is attached to the Negative (-) terminal.
g) Close the transmitter cover and replace the screws.
h) Reconnect the power connector.
Keep this Installation Manual in a secure place so the settings can be retrieved if needed.