Elkhart Brass Vulcan 8593-xx EXT - Manual (Page 23)

Page 23
NOTE – All six programming steps must be completed otherwise the changes will not
be stored to permanent memory!
(1) Hold the Red Programming Button (see Figure 18) on the controller
board until the programming LED flashes on (approx 5 seconds).
(2) To set the left hand limit run the monitor left until it has reached the
desired position. Quickly press and release the Red Programming Button.
The programming LED will flash once to acknowledge the new limit
position.
(3) To set the right hand limit run the monitor right until it has reached the
desired position. Quickly press and release the Red Programming Button.
The programming LED will flash twice to acknowledge the new limit
position.
(4) To set the left/right stow position of the monitor, move the monitor to the
desired position. (Note – The stow position must be between the right and left
limits that were just programmed in the previous two steps.) Quickly press
and release the Red Programming Button. The programming LED will flash
rapidly several times to acknowledge the new stow position.
(5) To program the vertical stow position set switch A position 1 to “ON” for
stow up or to “OFF” for stow down (Receiver only). NOTE: The up/down
stow position will either be all the way up or all the way down, nowhere in
between.
(6) Remove power from the monitor for a minimum of 5 seconds. Reapply
power and operate the monitor to verify that the travel limits are at the
correct positions and that the monitor stows correctly.
Caution:
Limits should be verified to be correctly set after the limits have been
programmed. If the monitor does not stop at the programmed limit positions then re-program the
limits. Checking limits should be part of normal truck maintenance.
d) To set the stow position without limits perform the following six steps (Note: – Do
not move the monitor at all while performing these steps. Doing so may inadvertently
program limits!)