Elkhart Brass Copperhead 8593-IV - Manual (Page 15)

Figure 16
The following steps outline how to install a valve gear actuator.
• Position the valve ball in the fully closed position
• Rotate the gear actuator hand wheel either fully clockwise
so that the actuator shaft will engage with the ball in the
closed position
• Install the gear actuator on the valve body in the proper
orientation (see Figure 16)
• Install the 4 socket head cap screws that attach the gear
actuator to the integral valve body (see Figure 15)
• Install the gear case cover and the four socket head cap
screws that attach the gear case cover to the gear case
(see Figure 14)
Note: The monitor is specially design for low maintenance and durability in the harsh
desert environment. Special fully synthetic grease is used on both vertical and horizontal
monitor swivel joints for increased longevity. No monitor components require routine
greasing.