Handle position – Elkhart Brass Single Body Valves User Manual
Page 8
Advertising
8
ELKHART BRASS MANUFACTURING COMPANY, INC
A) Remote and Direct Handle Positioning
1. Remove the 3/16 - 16" bolt and washer that locks the handle in position.
Figure 3
2. Remove the handle completely from the shaft and rotate to the desired location in 45°
increments. Remove and rotate the stop plate 90° to reverse valve ball rotation.
Figure 4
3. Place handle back on actuator shaft in new location and reattach washer and 3/8 - 16"
bolt. Use Loctite #242 thread locker or equivalent.
Figure 5
Remove handle
and rotate in
45° increments
Stop Plate
2. Handle Position
The remote and direct handle actuators may easily have the handles repositioned in 45° incre-
ments. The following details the handle reposition procedure.
Advertising