ElmoMC SimplIQ Digital Servo Drives-Guitar Installation Guide - Manual (Page 25)

Guitar Installation Guide Installation
MAN-GUIIG (Ver. 1.601)
www.elmomc.com
25
3.7.2. Connecting Main Power
Connect the VP+, PR and PE pins on the Guitar in the manner described in Section 3.5
(Integrating the Guitar on a PCB).
Note: The source of the 12 to 195 VDC Main Power Supply must be isolated.
Figure 6: Main Power Supply Connection Diagram (no Auxiliary Supply)
3.8. Auxiliary Supply (for drive logic)
Notes for auxiliary supply connections:
• The source of the Auxiliary Supply must be isolated.
Connect the VL and PR pins on the Guitar in the manner described in Section 3.5 (Integrating
the Guitar on a PCB).
Pin Function Pin Positions
VL Auxiliary Supply Input
PR Supply Input Return
Caution:
Power from the Guitar to the motor
must come from the Main Supply
and NOT from the Auxiliary Supply.
Table 2: Auxiliary Supply Pins