ETC 2U and 3U Rack Mount Kit Setup Guide - Manual (Page 3)

E T C S e t u p G u i d e
Rack Mount Kits
Rack Mount Kits Page 3 of 3 Electronic Theatre Controls, Inc.
3U Rack Mounting Instructions
The 3U Rack Mount kit (4250A2024) may be used to mount the Eos Remote Processor Unit (RPU) into
a rack enclosure. The Eos RPU requires 3U of rack space. Rack mounting the RPU requires both the
front and rear mounting brackets.
Install Front Rack Mounting Ears
Step 1: Remove the four rubber feet from the bottom of the unit.
Step 2: Locate the rack mounting hardware kit. It includes two front rack-mounting brackets and
10 screws.
Step 3: Align the mounting brackets to the appropriate sides of the RPU and attach them using
the screws provided as shown below. The brackets are interchangeable and will attach to
either side of RPU.
Install Rear Rack Mounting Ears
Step 1: Locate the two rear rack-mounting brackets (left
& right) and rail adapters found in the rack
mounting hardware kit. The rear rack-mount
ears are not interchangeable and must be
attached to the proper side of the RPU.
Step 2: Attach the brackets to the rail adapters as
shown at right.
Step 3: Attach the combined bracket-adapter to the
RPU using the two 3/8” screws. Insert the
screws up through the bracket and into the
bottom side of the RPU as shown below.
.
Step 4: Repeat steps 1-3 for installation of the second bracket and adapter.
Step 5: Install the RPU in the equipment rack using the appropriate rack-mounting hardware.
N o t e : If you wish to change the labels for the RPU buttons, you must do so before
attaching the rack mount brackets.
Bracket Rail Adapter