ETC Eos Family Show Control - Manual (Page 12)

10 Eos Family Show Control
.
• Event - is the event number, used to select or create a specific event from the command line.
Can also use [Next]/[Last] to select/navigate through the events.
• Time/Address - used to specify when the event should trigger the action. This could be either
time code, time of day, or an address used for analog inputs.
• Date- used to specify when the event should trigger the action, used only for RTC. See “Real
Time Clock (RTC)” on page 17.
• Action - is what the event is going to trigger; can be a cue, submaster, or macro.
• Label - names a specific event.
Event List
The lower portion of the show control display contains the event lists used in the console. Events
are contained within a specific event list (like cues within a cue list). Each event list has a specific
show control protocol type that it uses: MIDI, SMPTE, Analog, or RTC. Getting started with an event
list is the same regardless of which show control protocol you are using.
Softkeys will be available for the various event list options.
N o t e : The event number is not fixed, it is just a handle to select an event. For example,
in time code lists, the events are always chronological. The event number will
change to match the chronology.