ETC Net3 Conductor Network Services Gateway Setup Guide - Manual (Page 3)

E T C S e t u p G u i d e
Net3 Conductor
Net3 Conductor Setup Guide Page 3 of 4 Electronic Theatre Controls, Inc.
Connect
Complete the Net3 Conductor unit connections as defined below:
Step 1: Connect an Ethernet cable (not provided) between the ETC Net3 Ethernet network and
the Primary Network Interface connector.
Step 2: Plug the provided DC power input cable into the power input receptacle on the rear panel
of the unit and tighten the locking ring for a secure connection.
• An regional specific power supply kit has been provided. Select the appropriate
connector (specifically EU regions) from the power supply kit and assemble the
cable to the power supply then connect to the power source. Tie back the power
supply in the rack, taking care to ensure the power supply is supported
independently of the power connections.
Step 3: When using an external network (external of the ETC lighting network) to access the Net3
Conductor for SMS and e-mail messaging of log reports and error data, connect the
external network to the Secondary Network Interface connector.
N o t e : ETC highly recommends the Net3 Conductor is not connected directly to the internet
without an appropriate firewall or network address translation system in place. When
working in a corporate environment or building network system, consult your network
system administrator for assistance in setting up a secured connection.
* Unlabeled connections are not used.
DC Power Input
• 12Vdc, 5A max
ETC NET3 Network
NET3 Network/Switch
• 10/100 Mbps data
speeds
• Auto-sensing
• RJ45 compatible
Secondary Network
External Time Synchronization
• 10/100 Mbps
• Auto-sensing
• RJ45 compatible