ETC Net3 Conductor Network Services Gateway Setup Guide - Manual (Page 4)

E T C S e t u p G u i d e
Net3 Conductor
Net3 Conductor Setup Guide Page 4 of 4 Electronic Theatre Controls, Inc.
Initial Power Up and LED Status
The LED on the front of the Net3 Conductor provides information about the state of the device. During
normal operation, the indicator remains lit.
Step 1: Apply power to the unit. On the initial power up, the Net3 Conductor unit will remain
powered off until the power switch is activated.
Step 2: Press the power button located on the front panel to power up. The power indicator will
illuminate in blue when the unit is powered on.
• During the power up and shut down cycles, the power indicator flashes.
Web Interface
Net3 Conductor is provided with a built-in web interface, accessible only through the use of a web
browser. The web interface allows for:
• access to view and set the network IP and mode
• access to set up a secondary network connection as well as SMTP server settings
• ability to configure Windows File Sharing
• access to set and monitor the services provided over the network; such as DNS server, NTP time
server, File Sharing access, and the DHCP server
• ability to configure logging features, including saving and clearing data and setup of log backup
destinations
• ability to generate a backup of the current configuration and upload a configuration
• ability to upgrade Net3 Conductor software
• ability to reboot, shutdown, or restore the factory defaults to the Net3 Conductor
• ability to set up email alerts, set up rules, and post HTTP actions for system error events
Step 1: To view this web interface, physically connect and configure a computer to the same
network as the Net3 Conductor.
Step 2: Launch the desired web browser (Internet Explorer 7 or newer, Firefox, etc).
Step 3: Enter the Net3 Conductor IP address in the address line of the web browser. The factory
default IP address is 10.101.50.60.
For further configuration information, reference the Net3 Conductor built-in help system by clicking on
the “Help” tab at the left side of the web interface screen.
N o t e : In case of a power loss, the Net3 Conductor restores to the previous power state when
power is restored.
N o t e : During a firmware update, the power LED will flash progressively. When the update is
complete, the power LED returns to a solid state.
USB 2.0
Power button
• Press and release to power up or shut down
• Solid LED indicates power on