Euramco Safety VX700 - Manual (Page 8)

7.0 Preparation for Use When Supplied with Trailer
7.1 Optional Trailer Preparation
1. Check the trailer hand brake for proper operation. The trailer should roll freely when
the brake is released. The trailer should not roll when the hand brake is engaged.
2. If the trailer moves while the hand brake is applied screw the hand cap on the brake
handle clockwise a few turns to tighten brakes until the trailer can't be moved when
the brake is engaged.
3. Check tire pressure to ensure tires are inflated to 45 psi.
7.2 VX700 Preparation for Use
1. Position the VX700 on a level surface.
2. Ensure the Emergency OFF Switch on the control panel is in the OFF (down) position
and remove the motor ignition key.
3. Remove the inside access panel, (between motor and battery compartment), to the
battery compartment.
4. Clip the ty-wrap that secures the negative battery cable to nearby fuel and water
hoses.
5. Burnish the negative battery terminal and the battery cable clamp with a battery post
cleaner.
6. Attach the negative battery cable clamp to the negative terminal of the battery and
tighten. Reinstall the access panel.
7. Fill the Honda motor crankcase with oil as described in the HONDA GX630 owner's
manual. Use extreme caution to prevent oil from overflowing the port on top of the
motor.
8. Add gasoline to the fuel tank. Avoid using fuels that are high in methanol or ethanol
additives. If used methanol fuels must contain cosolvents and corrosion inhibitors.
Page 7