EZWatch Pro 3.1 - Manual (Page 3)

Back to the “AutoPlay Menu”, click on the
“Install Video Compression” link to start the install
of the two supported video compression types.
They are MPEG4 and Wavelet.
Note: Upon starting the install of either Mpeg4, or
Wavelet, if you see a screen saying “Mpeg4 or Wavelet,
already installed, continue or not?” Select “No” and cancel
the installation. Window’s XP already
has a built in Mpeg4 and Wavelet codec, therefore you
do not need to install the one we provide. If you don’t
see this message, continue below with the install.
First, click “Install MPEG4” to start the installation.
MPEG4 is now installed. You may get a splash screen
saying “Mpeg4 already installed, continue or not?”
Select yes and continue with the install.
Now, click on the “Install Wavelet” link to start
the installation. Wavelet in now installed. You may get
a splash screen saying “Wavelet is already installed,
continue or not?” Select yes and continue with the install.
Ezwatch Pro 3.0 HD is now installed. Now you can turn the computer off, unplug the power cord
from the back of the machine, and continue to the Video Board Installation section.
Step 3:
(For board #CP-1416ASE or CP-3416ASE)
Insert the EZWatch Pro 3.0HD CD into your CD-ROM drive,
the EZWatch Pro 3.0HD installer will appear automatically within
30 seconds listing all the available software. Select "EZ Watch
Pro 3.0HD 1416ASE / 3416ASE". If the Ezwatch Pro 3.0
installer does not appear on the screen automatically,
click "Start", then "Run" and execute “d:\setup.exe”
or whatever drive letter pertains to your CD-ROM drive.
Now, the installer should have launched for you, so
click next to begin setup. You should see the following
screen asking you where you would like to install
Ezwatch Pro 3.0HD. Click next if you would like to
Install in the current location. In case you would like
to install into another location, click browse and select
the location that you would like to install Ezwatch Pro 3.0HD.
You will see the installer copying the Ezwatch Pro 3.0HD
files to the location you selected. When finished copying files,
setup will ask if you want to restart your computer now or
restart later. Click “No I will restart my computer later”
and click finished.