EZWatch Pro 3.1 - Manual (Page 6)

Video Board & Driver Installation (Continued)
Step#2: Once the wizard has completed copying files
to your computer, you will see “Completing The
Found New Hardware Wizard” screen. Simply choose
Finish at the bottom and the wizard will have successfully
installed the first device driver for you.
Note:
Each video capture card that you install in your
computer will prompt you to install two drivers. One for
the Video and one for the Audio. The step just performed
installed the driver for the video. You will also install a video
driver for each card as show in step #3 below. So you will
need to repeat the process twice for each card you install.
Step#3: Now install the second driver for the video capture card the exact same way as before. This
time you will notice that it is installing the audio driver.
The install should go fairly fast for the audio driver. So once it is installed, click finish to complete
the setup. Once again, if you have installed more than one card, you will need to repeat the
above process for each card. After you have installed each driver for all the boards you have
installed in the computer, you can restart your computer.
Ezwatch Pro 3.0 HD is now installed, proceed to the next page to
setup a few Windows settings before running the EZWatch software.