EZWatch Pro 3.1 - Manual (Page 5)

Video Board & Driver Installation
Step #1: Find an Open PCI Slot Step #2: Insert Card Step #3: Fasten Card Down
Note:
One PCI slot is needed per Video Capture Card. Also make sure that the power cord is removed
from the back of your computer before installing the video capture cards.
Once the software has been properly installed, you can now shut down your computer and remove any
side panels so that you can insert the video capture boards. Follow Steps #1, #2, and #3 shown above to
properly insert the video capture cards. Once cards are properly inserted in the computer, you can put the
side panels back on and plug back in the power cord. Turn on your computer.
Once your computer starts back up, the “Found New Hardware Wizard” will appear on the screen
prompting you to install the drivers for the video capture boards. Follow the steps below to install the
video capture board drivers. This step must be correctly completed for the system to operate!
Note:
If your computer is running the current service pack in Window’s XP (Service Pack 2) then the
“Found New Hardware Wizard” will first ask you if it can connect to the Internet to search for a suitable
driver. Choose the third option > No, I do not want to search, and continue with the steps below.
Step#1: The found new hardware wizard should now be
displayed on your screen as shown to the right. Simply
choose the default option “Install the software automatically
(Recommended)”and click next at the bottom.
Note: You may also get a warning screen like the one below
from Window’s telling you that the driver’s you are installing
have not passed Window’s Logo Testing.
Choose “Continue Anyway” to continue with the driver install.