Bushnell ONIX 36-1100 - Manual (Page 24)

24
Troubleshooting
Problems Possible Solution
I pressed the power button but
the device doesn’t switch off.
Make sure that you hold the power button
for two seconds to turn it off. If the unit still
doesn’t turn off, remove the battery or the
power source for five seconds and install it
again.
The unit does not respond
when I try to move the cursor.
The map position may be latched. Check if
the symbol is shown in the bottom right
corner of the map page. If so, press and hold
a direction key to unlatch the device.
What do I do to return to my
current position on the map
page after I have moved the
map?
Check if the symbol is showing in the
bottom right corner of the map page. Press
the ESC button to return to your current
position
The ONIX 110 fails to locate my
current position .
Make sure that you are not in simulation
mode.
Make sure you are in an area with no
obstruction such as trees or tall buildings.
The ONIX 110 requires synchronization with
at least three satellites to identify with your
current location. Once the position has been
identified, it requires at least one satellite to
maintain status. If available satellite signals
are too low in orbit or all in a line, it may not
be able to locate your current location