Bushnell ONIX 36-1100 - Manual (Page 6)

6
Charging the ONIX 110 Battery
Before using your ONIX 110 for the first time, the internal
rechargeable battery must be fully charged, via the USB port
on the unit. Connect the supplied USB cable to the ONIX 110,
then connect the other end of the cable to the AC Charger. Plug
the charger into an AC wall outlet, and allow the unit to charge
until the battery charge icon on the unit’s display indicates a
full charge (this typically takes 4-5 hours). Once fully charged,
disconnect the AC charger and USB cable, storing them for
future use. The USB cable is also used for data transfer between
the ONIX 110 and a PC computer, using the PC Companion
software included on the CD-Rom (see “Installing the PC
Companion” on pg. xx) .
Turning On For the First Time
To turn on your ONIX 110 Handheld GPS Navigator, press and
hold the Power button for two seconds. The product info page
is displayed, then the Mode Selection menu appears. Use
the navigation keys to select a mode (see “Using the ONIX
110 Modes” on the next page) and press the OK button. Press
the Menu button twice and select Satellite. The unit will start
acquiring satellite information. Note: When the ONIX 110 is
used indoors, the device may not receive a sufficient GPS
signal and a warning message will appear on the screen. This
warning message does not go off unless you select “GPS Off”
in the Menu.
Acquiring Satellite Information
The satellite page displays information obtained from the
GPS satellites (Fig. 1). The upper half of the screen displays the
satellites found in the vicinity and their respective numbers.
The vertical bars on the bottom of the screen show the signal
strengths acquired from the satellites. The GPS requires at
least 4 satellites to determine its position, then the position
coordinates are displayed at the bottom of the screen. Note:
For optimal performance, the ONIX 110 must have its position
determined by the satellites.
Viewing the Map Page
Press the Page button to toggle between the map page and
the navigation info tabs page. On the map page, a triangle
icon indicates your current location and the “house” icon
indicates your home location. Press the Menu button to start
navigation.
Fig. 1