Heidolph Incubator 1000 - Manual (Page 20)

20
E

Secure lower half (C) on heater module; use 2 ea. knurled bolts from your hardware bag.

Place hood (D) on lower part.To do so loosen fastening screw (H) by turning counter-
clockwise until gap is ca. 6mm. Align hinges to an upright position. While mounting hood
(D) place threaded part of fastening screw (H) in slash of hinges (J).

Tighten fastening screws (H).

Open hood and plug deflector plate (F) in cutouts of lower half (C). This plate is important
for proper distribution of hot air under the hood.

heater module power supply is independent of shaker and mixer. Heating module comes
with its own power cord. Use handle (L) to open/close hood (D).

When closed, the integrated magnets (M) keep the hood (D) in position.