Hydro-Logic StealthRO200 - Membrane Flush Kit - Manual

1) Remove the existing flow restrictor from your Reverse Osmosis unit by pushing in on the collets on the
quick connect fittings and pulling the tubing out. Leave the short piece of black tubing connected to the automatic shut-off valve.
2) Insert flow restrictor into flush kit by pushing the open ends of the tubing into the quick connect fittings.
Make sure the arrow is pointing in the direction of water flow (away from the RO unit)
This kit allows you to bypass the flow restrictor and "power flush" the membrane(s) to remove scale build-up
and organic and inorganic contaminants from the membrane surface. By flushing the membrane(s)
regularly you can help extend the life of the membrane(s). Ideally, you want to flush the membrane(s) for
3-5 minutes directly after every time you use the Reverse Osmosis unit.
Installation instructions:
Flow Restrictor
Instructions Continued on Back
Automatic Shut-Off Valve.
(A.S.O.V.)