INCRA Mast-R-Lift II - Manual (Page 5)

Figure 9
1. Place the insert ring into the center hole
of the Lift’s top plate (Fig. 5).
2. With the insert wrench provided, insert
the prongs of the wrench into the
corresponding holes in the insert ring
and turn the insert ring counter
clockwise to tighten.
Turn the insert wrench clockwise to loosen and
remove the ring. If the insert ring becomes too
tight to loosen with hand pressure, a tap
clockwise on the insert wrench with a block of
wood will loosen it.
ADJUSTING THE FIT IN THE TABLE PORT
Your Mast-R-Lift™ II comes with adjustable
snugger bars to allow for a tight fit in the
table top opening and eliminate any
movement of the plate. Use the 3/16” hex
key provided to loosen the cap screws on the
snugger bars. Move the bars out slightly and
check for fit. Adjust again if necessary. (Figure
9) The INCRA Special Edition model also
includes the top mounted CamLOCK plate
locking system. See included addendum for
instructions.
Figure 10
TAB-LOC PHENOLIC INSERT RINGS
Note: The INCRA Special Edition Mast-R-Lift™ II
incorporates INCRA’s 5 Piece MagnaLOCK Ring
Insert System in place of the Tab-Loc Rings
described below. See included addendum for
instructions. Your Mast-R-Lift™ II comes with
one 2” insert ring with a pre-drilled center hole.
Additional ring sets are available with different
diameter pre-drilled holes and/or no pre-drilled
holes for creating your own custom center hole
diameters. See your JessEm distributor for these
and other accessories.
USING YOUR MAST-R-LIFT™ II
To raise your router, turn the height
adjustment handle clockwise. To lower,
turn the handle counter-clockwise. Keep in
mind that one complete revolution equals
1/16” of change. When your adjustment is
complete, remove the handle and place
somewhere off the work surface for safety.
Refer to the chart below for fractional and
decimal adjustments based on amount of
revolutions made.
Fraction
Decimal Number of
Revolutions
1/64” 0.016” 1/4 Revolution
1/32” 0.031” 1/2 Revolution
1/16” 0.062” 1 Revolution
1/8” 0.125” 2 Revolutions
1/4” 0.250” 4 Revolutions
1/2” 0.500” 8 Revolutions
With the Mast-R-Lift™ II you have the
added benefit of locking your Lift in a
desired position for long term routing
operations and having the comfort in
knowing the position you have set is
locked in place.
USING THE CAM LOCK ON YOUR MAST-R-
LIFT™ II