INFICON Cygnus Thin Film Deposition Controller - Manual (Page 84)

3 - 16
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
TURRET DELAY . . . . . . . . . . . . . . . 1 to 60 sec (default = 5)
If Turret Feedback is not used a timer will be set to allow the source crucible
time to rotate into position. This parameter sets the amount of time the Process
will remain in the Crucible Switch state waiting for the crucible to rotate before
proceeding to the Rise 1 state.
CAUTION
The Channel will proceed to the Rise 1 state after the
Turret Delay time expires. This could result in damage to
your equipment if the crucible is not in position after
expiration of the Turret Delay time.