I.R.I.S. 565 User Manual
Page 6
Installation Instructions
TED65 is designed to be panel mounted into a dashboard or helm. The front of the unit is water
resistant but the rear of the unit isnʼt, so if installing in an external helm ensure a suitable water
resistant silicone sealant is used around the panel cut-out when fixing the unit in place. Also ensure
there is suitable ventilation around the back of the unit and take care not to site the devise in a
position where there is excessive heat behind the panel. Allow enough space to around the unit to fit
the data adapter and power plug.
Version 1.00. March 2012. ©Iris Innovations Limited.
169mm
126mm
Fixing Points
The bezel is fixed onto the frame of the unit using M3 x 3mm machine screws around the
frame. To screw fix the unit into your panel remove bezel screws as required and replace
with screws that are long enough to go through the panel, through the frame and lock into
the bezel. For example, if your helm is 7mm thick, remove screws as required from the
bezel and replace with 10mm screws. 4 x M3x10mm machine screws are supplied.
Panel Cut-Out
Bezel
Frame