I.R.I.S. 565 User Manual
Page 8
Power and Data Connections
Power your unit from a dedicated fuse / breaker rated at 12VDC / 600mA. The unit operates when
power to the breaker / fuse is applied. Ensure suitably rated cable is used to handle the required
current and voltage.
A DC jack/Phoenix Screw Terminal plug adapter is provided to simplify power connection. If you
decide to use this adapter ensure to observe the polarity markings shown. Connect +12vDC to the
terminal marked + and connect the Ground to the terminal marked -.
Data communications to cameras and other devices is achieved via the unitʼs serial port. An RS232
to RS485 data convertor is supplied and must be connected to the serial port. The convertor has a
DSUB9 connector that plugs directly into the serial port and screwed into place. At the opposite end
of the convertor is a convenient screw terminal block marked + and - into which the RS485 data line
is wired.
Back Panel Details / Connections
(Items listed in grey are not currently used and reserved for future use).
1. Product label with regulatory information.
2. Power Connector 12VDC 600mA (Phoenix Combicon MSTB 2.5)
3. RJ45 Ethernet Connector (LAN).
4. 2 x USB Host
5. 2 x USB Host
6. RS232 Serial Port
7. MicroSD Card Slot
8. Dip switch Bank
9. CAN Bus
10.RS232 Port
11.Mounting Hole for Wall Clamps
12.M4 Screw Hole (x4) for FDMI (VESA) mounting
Version 1.00. March 2012. ©Iris Innovations Limited.
Power Jack Adapter
RS232/RS485 Data Adapter