I.R.I.S. 808 Digital Video Recorder - Manual (Page 92)

Out relay and the Buzzer will keep being triggered after the speed alarm is
triggered. However, the Alarm Out relay and the Buzzer will be reset
immediately once the speed alarm returns to normal, i.e. speed under the
threshold. Press +/- buttons to adjust the value (3 seconds - 60 minutes, discrete,
‘-‘ for ‘Forever’).
 Goto Preset – to define the preset position to go to for the Focus Camera if the
speed alarm is triggered and the Focus Camera is a PTZ camera. For more details
about preset locations, please refer to
Chapter 7 PTZ Control .
 Pre-record – to define how long before the speed alarm is triggered the Focus
Camera shall be intensively recorded at Pre-record IPS. Press +/- buttons to
adjust the value (0-10 seconds, discrete). Please note that the actual pre-record
time may be shorter than the value set if the total size of the pre-record pictures
exceeds the pre-record buffer size of the system.
 Post-record – to define how long after the speed alarm is triggered the Focus
Camera shall be intensively recorded at Event Record IPS. Press +/- buttons to
adjust the value (0 second - 60 minutes, discrete).
 Alarm Out – to define which Alarm Output will be triggered when the speed
alarm is triggered. Press +/- buttons to select none (N/A) or one of the Alarm
Outputs (1-2).
 Buzzer – to activate the internal Buzzer or not when the speed alarm is triggered.
Press ENTER or +/- to check/uncheck this item. The default setting is “ˇ” -
checked.
 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
 Screen Message – to display the event message on the screen or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.
 E-mail – to send the event e-mail to remote station or not. The e-mail will be sent
to the predefined receivers when the event is triggered. Press ENTER or +/- to
check/uncheck this item. The default setting is “–” - unchecked.
 FTP – to send the recorded event video/audio files to FTP server or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “–” -
unchecked.
92