Rl r l, Wearing the mono headset with an ear hook – Jabra BIZ 2400 USB User Manual User Manual
Page 6
6
how to press the headset into the headband ring on the headband.
Hold the headband in one hand and the headset in
the other. Align the headset against the outside of the
headband ring with the headset cable pointing down.
Gently press the headset into the headband ring until it
clicks into place.
wearing the mono heaDset with an ear hook
Two sizes of ear hook are included with some Jabra BIZ 2400 models, they can also be purchased as an accessory
for any mono model. To use it:
1. how to attach the ear gel.
The ear gel is a round rubber part which helps stabilize the headset
on your ear. Place the ear gel inside the
ear hook ring. Gently push the ear gel through the hole so that it sits
in the hole. Once you click the headset into the ear hook ring, the ear
gel will be locked into place.
2. how to press the headset into its ear hook ring on the ear hook.
Hold the ear hook ring in one hand and the headset in the other.
On the inside surface of the ear hook ring you will find "L" and "R"
markings. Align the cable of the headset with the "R" marking if you
wish to wear it on you right ear, or "L" if you wish to wear it on your left
ear. Gently press the headset into the ear hook ring until it clicks into
place.
3. how to position the ear hook on the ear hook ring for left or right ear use.
The ear hook wearing style has two parts: an ear hook and an ear hook
ring. One end of the ear hook forms a pin that presses into a loop on the
ear hook ring and holds it there.
You will wear the headset with the ear hook behind your ear and the ear
hook opening pointing down towards your jaw. Decide on which ear you
would like to wear the headset and assemble the ear hook and ear hook
ring appropriately.
To change from one ear to the other, pull the ear hook up and away from
the loop, and press into the other side of the loop. Then remove the
headset from the ear hook ring. Rotate it and replace it again with the cable
positioned at the ‘L’ or ‘R’ for the selected wearing side as described in point 2.
R
L
R
L