Introduction, Packaging & contents, Installation – Johnson Systems DPC-24-3000 Series Digital Pack Controller User Manual

Page 3: Introduction packaging & contents installation

Advertising
background image

www.johnsonsystems.com

3

Introduction

Digital Pack Controllers (DPC’s) are a next generation retrofit electronics

package designed specifically for upgrading Strand CD80 12 channel and 24

channel portable dimmer packs, as well as 48 channel compact rolling racks.

This direct plug-in replacement control module supersedes all previous

generations of OEM and aftermarket controllers in both reliability and

features.

“Basic Mode”, on power up, was designed specifically at the request of

major U.S. studios and rental houses. Advanced features for the more

selective user allow customization of over 30 additional features. Advanced

next generation “3000 Series” hardware and software designs reduce

stand-by power consumption to less than 1 Watt. Exclusive “lamp warming”

techniques extends lamp life considerably.

Packaging & Contents

DPC-12 and DPC-24 retrofit control modules are shipped in a custom

designed box and packaging for protection of the unit. It is recommended to

keep the box and packaging stored in a safe place. In the unlikely event that

the system needs to be returned to the JSI Factory, the packaging will help

prevent shipping damage and maintain warranty.

Installation

DPC-12 and DPC-24 retrofit control modules are a “plug-and-play”

replacement for the OEM (Original Equipment Manufacturer) CD80 dimmer

pack control module.

• Disconnect (turn off) the power supply to the CD80 dimmer pack.

WARNING! Verify all power is disconnected (turned off) before proceeding.

Removal of the old CD80 pack control module

• Loosen the two (2) thumbscrews located on each end of the control

module.

• Carefully pull straight out on the thumbscrews to remove the control

module.

• Determine if the DMX input is connected internally, on a terminal block

mounted inside the CD80 dimmer pack. If it is, determine which rear

connector the DMX comes in though.

Installation of the new DPC-12 or DPC-24 retrofit control
module

• Remove your new DPC-12 or DPC-24 retrofit control module from the

box.

DPC-12

DPC-24

Advertising
This manual is related to the following products: