Brinkmann Sl 7 - Manual (Page 7)

6
Terminal
Wire Connector
Changing Batteries
1. Unscrew the four screws in front housing and
separate it from rear housing.
2. Carefully peel the tape off the battery, leaving
wires attached to tape.
3. Remove the battery from rear housing, being
careful not to pull on wires.
4. Disconnect wires from battery terminals and
remove battery.
5. Connect wires to new battery terminals. Make
sure red (+) wire is connected to red (+)
terminal and black (-) wire is connected to
black (-) terminal.
6. Place new battery in rear housing.
7. Attach tape and wires to front of battery.
8. Attach the front housing to rear housing using
the four screws that were removed in Step 1.
9. Place switch in the “OFF” position and charge
in FULL, DIRECT SUNLIGHT for THREE FULL
DAYS. Then slide the switch to the “AUTO”
position. The light will turn on automatically at
night when it detects motion.
IMPORTANT: The sealed battery in this product
contains lead and must be
recycled or disposed of properly.
For additional information
regarding disposal, contact your
local county solid waste authority.
1. Turn lens counterclockwise and remove.
2. Pull bulb straight out and replace with new
bulb. DO NOT PLACE NEW BULB IN BRASS
GROMMET HOLES.
3. Replace the lens by aligning the slots with the
grooves in the top housing and turning
clockwise to lock in place.
Changing Bulb
Lens
Bulb
Tape
Battery
Rear Housing
Front Housing
Contains Lead-Acid (Pb) battery.
Battery must be recycled or
disposed of properly.
INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 7