Brinkmann Sl 7 - Manual (Page 8)

7
1. Clean snow and debris off the solar panel so the battery can recharge.
2. Check and replace battery periodically throughout the year, especially after
winter months.
Wintertime
Tips
Solar security lights can be left outside year round, even in cold weather.
However, if you wish to store your light indoors for more than two or three
days, follow these steps to prevent damage to battery:
1. Turn the switch to “OFF” position. Store at room temperature in a dry
area.
2. Never store unit with switch in “AUTO” or “TEST” position. This will
damage the battery and it will not recharge.
3. Store light and solar panel where it can receive some sunlight or room
light each day. The battery needs light to maintain a charge during
storage.
4. During prolonged storage, unit must be fully charged once every four
months. You may need to replace the battery after prolonged storage.
5. Never store the unit in a box or in a dark room without a source of light
on the solar panel or you may need to replace the battery before next use.
6. For best performance, do not store for prolonged periods.
Storage
Cleaning It is important that the solar panel is kept free of dirt and debris. A dirty solar
panel will not allow the battery to fully charge. This will shorten the life of the
battery and cause the light to malfunction. Clean regularly with a dampened
cloth or paper towel.
If lights blink on and off:
• Direct lamps away from detector or reposition detector.
• Remove heat sources located near or under detector.
• Direct detector away from streets or active sidewalks.
If lights do not turn on at night:
• Switch is in the “OFF” Position. When the switch is in the “OFF” position,
light will not turn on after dark. Move switch to the “AUTO” position and
check for normal operation after dark.
• Make sure the solar panel module cord is plugged firmly into main
housing. The battery will not charge if this connection is loose.
• Battery is not fully charged or needs replacement:
a. Make sure light is located in an area where the solar panel gets the
maximum amount of full, direct sunlight every day.
Troubleshooting &
Important Information
Solar Panel
Module Cord
INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 8