KD Scientific 200 Series - Manual (Page 25)

21
KDS Model 200 Series
Programmable Option– Menu Operation
(Continued)
8) Loop (Continued)
b) LOOP COUNT
After setting the initial step number of the loop, the menu will prompt for
the "loop count", the number of times the loop will be repeated.
Maximum repeat number is 100.
Display reads: # Loop Count: x
The number of loops to be executed, x is entered from the numerical
keypad followed by ENTER.
Note:
a) Maximum number of loops is two.
Once both loops are entered the loop option will NOT be displayed
in menu.
b) Changing Loops
To change loops, if two are already entered, one loop must be
cancelled before the new loop can be programmed.
c) A LOOP within a LOOP
It is possible to have a loop running within a loop.
9) Saving the Step
As there are many options in each step the program gives one more option,
"Redo" to make changes before storing the Step.
menu prompts: # Step: Save Redo
The arrow keys are used to highlight the required option which can be saved with
ENTER or SELECT.
10) Program End
After saving the step the program prompts: # Next Step Done
"Next Step" is selected, unless all steps are completed, and the above process is
repeated for the number of steps required, up to 8. When all steps are
programmed "Done" should be entered, with SELECT or ENTER to complete the
programming.
The pump and display will now move to Step 1 ready to start the programmed
dispense.
display reads: Stp 1 xx:xx:xx ➔