Kisan Electronics CX-10 - Manual (Page 15)

Page - 13 Page - 13
INSTALLATION
For those motorcycles, where the battery is under the seat, and inside an
enclosure, you may have to mount it along the rails or in a suitable
location nearby.
After you have chosen an appropriate
location, clean it thoroughly. Then, peel
the backing off the mounting tape and
affix the chargeX unit in place. Apply
pressure to hold it in place. Allow 24
hours for the bond to fully cure.
The 110V AC cord is 6 ft long, so you
can route it for an easy access. Please
note that the plug of the AC cord is
polarized. It should be plugged in a
properly wired AC outlet for
safety.
Route the AC cord so that the
plug is easily accessible for an
extension cord. Make sure that
the cord does not rub against
any sharp edge or get pinched
when reinstalling the seat.
„ For best results, allow 12
hours of first time charge to
enable chargeX to learn the best mode of operation.
chargeX installed under seat
DANGER OF ELECTROCUTION! The AC cord has UL approved
PVC jacket. DO NOT allow it to be cut or pierced in any way.
AC cord routed under seat w/plug access