Kisan Electronics CX-10 - Manual (Page 16)

Page - 14
LED STATUS INDICATOR
rgeX onboard
er LED indicator
shows operating status as
s:
voltage is
g
3-F
Ungrounded AC outlets, condensation near the outlet or
on the floor, or an overload from another appliance on
the
If you see a GFI fault – 3-flashes -
the AC outlet for a res
„ Make s
e condensation near the outlet
„ Make s
„ Use a p
t
cha
charg
follow
Continuous flashing – Fast for higher rate and slow for lower
rate of charge. It’s fully automatic.
Solid ON – Charging is completed and optimal battery
maintained. It will restart as needed to keep optimal voltage.
2-Flashes – indicates a fault in the output connection. It may
be a loose wire or a short-circuited connection. The chargin
function STOPS until the fault is corrected.
lashes – indicates a fault in the AC input.
same outlet will cause Ground Fault Interrupt (GFI)
chargeX unit must be unplugged from
et. Before you do that, for your own safety:
ure that there’s no excessiv
ure that the outlet is properly grounded and polarized
olarized extension cord, if not directly plugging into a wall outle
DANGER OF ELECTROCUTION! Unplug this appliance from the
outlet. DO NOT touch or step on to any wet surfaces.