Koolance ICM-505 - Manual (Page 30)

25 User Manual
The liquid coolant should be fi lled up to about 1.5 cm
(1/2”) from the reservoir’s top. This small gap will catch
air as it circulates through the system. Do not overfi ll.
It is recommended to keep paper towels on hand just
in case.
Allow the pumps to run for about 1-5 minutes. When fi ltration has ended,
the liquid rushing noise should stop. If the reservoir level becomes signifi -
cantly lower during this “bleeding” process, add more liquid coolant. (The
continuous sound of liquid rushing through the reservoir indicates that it
was overfi lled, or that it needs more coolant.)
Replace the refi ll tap screw.
The cooling system can be “jump-started” to assist
in the circulation process without booting-up the
computer. This will also allow you to check your
hose connections and make sure there are no folds
in the tubing.
CAUTION : Jumping the incorrect ATX power supply pins can cause
permanent damage to the power supply.
4 6
!
Make sure the AC power cord is attached to the power supply. If the power supply
has a rear switch, it must be in the ON (-) position. Using the ATX Jumper Wire,
insert the metal prongs into pin numbers 4 and 6 on the 20-pin motherboard ATX
power supply connector (green and a black ground wire-- See diagram).
That’s it! Replace the ATX motherboard connection and boot-up the computer.