Koolance ICM-510 - Manual (Page 17)

12
Installing the ICM-510
Hose Lengths
Before installing your liquid coolers,
appropriate lengths of tubing must be cut
to connect each device. If not already
installed, it may be easier to temporarily
lay your motherboard and video card inside
the chassis to better estimate the required
amounts.
Connect both ends of the included 6mm
(1/4”) hose to the ICM-510 inlet and outlet
nozzles. The tubing should now form a
simple loop without any attached coolers.
Roughly estimate the length you will
need from the ICM-510 to your fi rst
cooler, and cut tubing from the nozzle
marked “Out”.
Cut the hose from the “In” nozzle with
enough length to connect with the last
cooler that will be in your system.
Using the leftover tubing, cut shorter pieces
to link between each individual cooler.
Continue connecting all of your coolers in
the system until there are no longer any
open tubing ends.
Remember to leave enough tubing for the
ICM-510 to open easily on its hinge once
the coolers are mounted.