Koolance PC3-420SL - Manual (Page 12)

7
Power Control Board
You may begin the installation of your Koolance system by mounting a power
supply in the chassis. The liquid cooling system requires approximately 8-10W
from any standard ATX power supply.
Connect a 12-volt 4-pin Molex plug from the power supply to the Power Control
Board. Without this important connection, the Koolance system will NOT operate.
CAUTION
:
The Power Control Board is vital to system operation. A
12V 4-pin plug from the power supply must remain connected to the
circuit at all times while the computer is in use.
!
Connecting INX-420 Systems
ATX Power Switch
The ATX “pass through” lead is responsible for shutting off your computer if the LED
temperature (CPU cold plate) reaches 58ºC (136ºF).
Connect the male ATX power lead from the INX-420
to the chassis main power switch.