Koolance PC3-420SL - Manual (Page 15)

10 Filling & Maintenance
CAUTION
:
Jumping the incorrect ATX power supply pins can cause
permanent damage to the power supply.
!
Your Koolance system is designed to automatically filter air from the liquid. Before
filling, the cooling system should be “jump-started” to assist in the circulation pro-
cess.
Make sure the AC power cord is attached to the power supply. If the power supply has
a rear switch, it must be in the ON (-) position. Using the ATX Jumper Wire, insert the
metal prongs into pin numbers 4 and 6 on the 20-pin motherboard ATX power supply
connector (green and a black ground wire-- See diagram).
Testing & Filling
You should now hear the pumps running in an empty
reservoir.
The large, slot-headed refill tap is located above the
reservoir. Remove it with a flat screw driver.
With the reservoir open, insert the refill funnel.
4 6