Koolance PC3-420SL - Manual (Page 16)

11 User Manual
Cut a small corner in the coolant pack, and slowly fill the reservoir. You will probably
not need the entire amount of liquid.
WARNING
:
The liquid coolant is electrically conductive. Use caution
when filling the system, and keep all liquids away from computer
hardware and power cables. In case of emergency during installation,
immediately unplug the computer’s rear power cable. Dry the system
thoroughly before proceeding.
!
Do not overfill the reservoir. You should be able to
easily replace the refill tap without causing any liquid
to spill out. It is recommended to keep paper towels
on hand just in case.
Replace the refill tap screw and allow the pumps to
run. When filtration has ended (usually after about 1-5
minutes), the liquid noise will stop.
If the reservoir level is noticably depleted after this step,
you may need to add more liquid coolant and repeat
the process once more.