Koolance PC3-736SL - Manual (Page 23)

18
The liquid coolant should be fi lled up to about 1.5 cm (1/2”)
from the reservoir’s top. This small gap will catch air as it
circulates through the system. Do not overfi ll. It is recom-
mended to keep paper towels on hand just in case.
Allow the pumps to run for about 1-5 minutes. When fi ltration has ended, the
liquid noise should stop. If the reservoir level becomes signifi cantly lower
during this “bleeding” process, add more liquid coolant. (In the future, if
you begin to hear liquid rushing through the reservoir, it may indicate more
coolant needs to be added.)
Filling & Maintenance
Replace the refi ll tap screw.
The cooling system can be “jump-started” to assist
in the circulation process without booting-up the
computer. This will also allow you to check your hose
connections and make sure there are no folds in the
tubing.
CAUTION
:
Jumping the incorrect ATX power supply pins can cause
permanent damage to the power supply.
4 6
!
Make sure the AC power cord is attached to the power supply. If the power supply
has a rear switch, it must be in the ON (-) position. Using the ATX Jumper Wire,
insert the metal prongs into pin numbers 4 and 6 on the 20-pin motherboard ATX
power supply connector (green and a black ground wire-- See diagram).
That’s it! Replace the ATX motherboard connection and boot-up the computer.